Page 1 of 1
Mast specification
Posted: Mon Feb 22, 2016 4:41 pm
by MarkRyan1981
Hello all,
Triola is due back in the drink in a few weeks, so mast servicing time. Does anyone know if this is the original mast? Looks to be a Selden rig?
The sheaves all need replacing with something modern as they are a nightmare to pull up.
Bodged main halyard sheave pin
Sheaves I want to replace:
![Image](http://i.imgur.com/LMUJNTbl.jpg)
Re: Mast specification
Posted: Wed Feb 24, 2016 3:04 am
by Bob McGovern
Is a Selden mast & identical to ours (1972). Our top sheaves are also questionable. Will replace them with new; have to choose between ball bearing (for smoothness) or solid bushing (for strength & simplicity). And those axle bolts should be solid body, not all-thread!
Are you going with wire halyards again, or synthetics? We'll be probably switching to Vectran/Warpspeed/Technora or similar on main & genoa halyards; possibly Dyneema for spinnaker/Code Zero. Single braid synthetics will run fine in wire groove sheaves; double braids or covered halyards prefer a rope-specific sheave profile.
Re: Mast specification
Posted: Sun Feb 28, 2016 9:34 pm
by MarkRyan1981
Thanks Bob, hope you are well! My running rigging had already been done and replaced with non HMPE rope before I got her... I may well replace the main halyward with Dyneema or the like... depends if funds stretch!! (not the rope)
I am replacing with solid composite sheaves I think, measured all mine up and will place the order with a local rigger.
Re: Mast specification
Posted: Fri Mar 11, 2016 2:14 pm
by MarkRyan1981
Hello all, found the Selden part numbers.
The 70 mm sheave is 504-326 -
http://www.seldenmast.com/en/products/r ... 4-326.html
The clevis pin is part 165-403 -
http://www.seldenmast.com/en/products/r ... 5-403.html
Phew, boat in water TUESDAY, gads, parts arrive tomorrow, engine still in a million pieces too
![Laughing :lol:](./images/smilies/icon_lol.gif)