Hi,

I'm about to put in a new Jabsco  manual toilet but is uncertain how to place the pipework both securely and not obstructing the slideable washbasin.

 

The old installation felt a little bit risky due to the discharge going straight up to the bottom of the septitank with no vented loop with the (well there was a valve between, but is was way back in below the washbasin to be easy to use every time)  

 

My idea is to install the new pipework accordingly to the option 3 on the fig below, with the alteration that I will extend the 38 mm hose after the vented loop to go in at the existing tail at the bottom of the septitank and with a T-joint with a valve for the option of letting it go directly out through the seacock.

 

My question is if any of you have any good suggestions how to make all the pipework fit, how have you all set it up?

 

Thanks in advance

/M책rten

 

  

Our holding tank air outlet has somehow "jammed". It useually operates as the outlet of air from the holding tank, and it never lets the content out. Which is nice, since otherwise we would have it on the deck, when the tank is full. Now it seems to be permanently closed, since we cant pump anything into the tank, even after emptying it. hen trying we just raise the airpressure in the tank, and the content of the pump and the hose, is slowly pressed back into the toilet bowl.

 

Question: Can it be repaired? Can a new one be found? With the security valve included. Am I wrong? Is the valve not in the outlet, but somewhere in the tank, or in the hose?

 

Here are pictures of the thing in question

 

Outside:

 

 

Inside:

 

 

Best regards!  Jesper Milling

I have just purchased a Hull # 25 Albin Ballad and am looking for any ideas in holding tank placement. Any help would be appreciated.